AOSept Plus with HydraGlyde Economy Pack 2 pack

Directions and ingredients INSTRUCTIONS FOR USE:
1) Wash your hands and dry them with a clean towel
2) Open the lens holder marked L and place your left lens on the dome. Close lens holder taking care to avoid trapping your lens
3) Repeat procedure with your right lens placing it on the dome of the other lens holder marked R
4) Open the if top cap on the AOSEPT PLUS bottle and bend it back and out of the way
5) Thoroughly rinse the lenses in the lens holders with AOSEPT PLUS for 5 seconds
6) Fill the cup with AOSEPT PLUS solution to the ll-line. DO NOT UNDERFILL OR OVERFILL
7) Place lens holder in the AOSEPT PLUS cup and screw closed. Do not shake the cup
8) Store lens case upright. If bubbles leak from the hole in the top of the lens case's cap, non-neutralised AOSEPT PLUS solution may be present. Empty the solution from the lens case and wash o any spillage from the surface on which the AOSEPT PLUS lens case was standing. Thoroughly rinse the AOSEPT PLUS cup and lens holder with sterile saline. If spillage occurs, clean up immediately with a paper towel. Wash your hands thoroughly before handling your lenses or touching your eyes. REPEAT THE DISINFECTION PROCEDURE ABOVE
9) Allow lenses to soak for a minimum of 6 hours or overnight to neutralise solution
10) Remove your lenses from lens holder
11) Your lenses are now ready to wear
12) Discard used solution, rinse the AOSEPT PLUS cup and lens holder with sterile saline - DO NOT USE TAP WATER OR NON-STERILE WATER
13) Allow them to air-dry by inverting the lens holder outside the cup
14) If you do not intend to wear your lenses immediately after disinfection/neutralisation, you may store them in the neutralised AOSEPT PLUS solution, in the unopened AOSEPT PLUS lens case for up to 14 days. After this time, your lenses must be cleaned and disinfected with AOSEPT PLUS prior to wear. It is important to keep your AOSEPT PLUS cup and lens holder clean and free from contamination.
If recommended by your eye care professional: Rinse lenses before insertion with sterile saline.
CONTRAINDICATIONS (reasons not to use): Do not use if you are allergic to any of the ingredients, Never use AOSEPT PLUS for heat disinfection.

Hydrogen peroxide 3%, phosphonic acid, sodium chloride, phosphate, poloxamer, HydraGlyde Moisture Matrix.